B2394

B2394-FLASH TO PASS/OPTICAL HORN SWITCH CIRCUIT STUCK



- When Monitored:
With the ignition on.

- Set Condition:
The Cluster detects the Flash to Pass Switch Input circuit voltage is less than the expected value.





CHECK FOR AN ACTIVE DTC

NOTE: Before proceeding with this diagnostic procedure, verify the Left and Right Multifunction Switch and Clockspring harness connectors are properly seated and verify proper pin terminal tension. A loose connection at any of these connectors may cause this DTC to set.

1. Turn the ignition on.
2. Actuate the Flash to Pass/Optical Horn.
3. With the scan tool, read DTCs.

Does the scan tool display this DTC as active?

Yes

- Replace the Left Multifunction Switch.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.