All Wheel Drive Module (AWD)

C2206-VEHICLE CONFIGURATION MISMATCH



- When Monitored:
Continuously with the ignition on.

- Set Condition:
When the All Wheel Drive (AWD) Module detects an incorrect CAN messages from the Powertrain Control Module (PCM) or the Totally Integrated Power Module (TIPM).





1. TOTALLY INTEGRATED POWER MODULE (TIPM) CAN BUS DTCS ARE PRESENT
1. With the scan tool, read TIPM DTCs.

Are there any TIPM CAN BUS DTCs present?

Yes

- Testing and Inspection Perform the appropriate diagnostic procedure.

No

- Go To 2

2. POWERTRAIN CONTROL MODULE (PCM) DTCS ARE PRESENT
1. With the scan tool, read Powertrain Control Module (PCM) DTCs.

Are there any PCM DTCs present?

Yes

- Testing and Inspection Perform the appropriate diagnostic procedure.

No

- Using the schematics as a guide, check the AWD Module pins, terminals, and connectors for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits. If no problems are found, replace the AWD Module.
- Perform the AWD VERIFICATION TEST. AWD Control Module Verification Test.