C2208

C2208-AWD ECU INTERNAL



- When Monitored:
With the ignition on.

- Set Condition:
The All Wheel Drive (AWD) Control Module has detected a failure internal to the controller.





1. ACTIVE DTC
1. Ignition on, engine not running.
2. With the scan tool, read DTCs.

Is the DTC active at this time?

Yes

- Go To 2

No

- Go To 3

2. ALL WHEEL DRIVE (AWD) CONTROL MODULE
1. The AWD Control Module has detected an internal failure.

View repair

Repair

- Replace the All Wheel Drive (AWD) Control Module.
- Perform the AWD Control Module VERIFICATION TEST. AWD Control Module Verification Test.

3. INTERMITTENT WIRING AND CONNECTORS
1. The conditions necessary to set this DTC are not present at this time.
2. Using the schematics as a guide, inspect the wiring and connectors specific to this circuit.
3. Wiggle test the wiring harness and connectors while checking for shorted and open circuits.
4. Using the scan tool, monitor the data related to this circuit while performing the wiggle test. Look for the data to change or for the DTC to reset.

Were there any problems found?

Yes

- Repair as necessary.
- Perform the AWD Control Module VERIFICATION TEST. AWD Control Module Verification Test

No

- Test Complete.