B1094

B1094-FRONT LEFT SEAT HEATER CONTROL CIRCUIT OPEN (LHD)







- When Monitored:
Ignition on, during the heated seat operation.

- Set Condition:
This code sets immediately when the Heated Seat Module (HSM) detects that the (P187) Front Left Seat Heater Control circuit is open.





1. VERIFY DTC B1094-FRONT LEFT SEAT HEATER CONTROL CIRCUIT OPEN IS ACTIVE
1. Turn the ignition on.
2. With the scan tool, record and erase Diagnostic Trouble Codes (DTCs).
3. Operate the Heated Seat Switch in both positions several times.
4. With the scan tool, read DTCs.

Is DTC B1094-FRONT LEFT SEAT HEATER CONTROL CIRCUIT OPEN active?

Yes

- Go To 2

No

- The conditions that caused this code to set are not present at this time. Verify seat harness is routed correctly. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors. Look for chafed, pierced, pinched, or partially broken wires and broken, bent, pushed out, spread, corroded, or contaminated terminals. Attempt to reproduce condition by adjusting the seat.
- Perform BODY VERIFICATION TEST. Body Verification Test.

2. CHECK FOR OPEN SEAT HEATER ELEMENTS




1. Turn the ignition off.
2. Disconnect the Driver Seat Cushion Heater connector.

NOTE: Check connectors - Clean and repair as necessary.

3. Measure the total resistance of the Cushion and Seat Back Heater Elements between the (P187) Front Left Seat Heater Control circuit and the (Z921) Ground circuit at the Driver Seat Cushion Heater connector (component side).

Is the total resistance 4.5 ohms + or - 0.5 ohms?

Yes

- Go To 3

No

- Go To 5

3. CHECK (Z921) GROUND CIRCUIT FOR AN OPEN




1. Measure the resistance of the (Z921) Ground circuit between ground and the Driver Seat Cushion Heater connector (harness side).

Is the resistance below 5.0 ohms?

Yes

- Go To 4

No

- Repair the (Z921) Ground circuit for an open.
- Perform BODY VERIFICATION TEST. Body Verification Test.

4. CHECK (P187) FRONT LEFT SEAT HEATER CONTROL CIRCUIT FOR AN OPEN IN BODY HARNESS




1. Disconnect the HSM connector.

NOTE: Check connectors - Clean and repair as necessary.

2. Measure the resistance of the (P187) Front Left Seat Heater Control circuit between the HSM connector and the Driver Seat Cushion Heater connector (harness side).

Is the resistance below 5.0 ohms?

Yes

- Replace the Heated Seat Module (HSM).
- Perform BODY VERIFICATION TEST. Body Verification Test.

No

- Repair the (P187) Front Left Seat Heater Control circuit for an open.
- Perform BODY VERIFICATION TEST. Body Verification Test.

5. CHECK DRIVER SEAT BACK HEATER ELEMENT FOR AN OPEN




1. Disconnect the Driver Seat Back Heater connector.

NOTE: Check connectors - Clean and repair as necessary.

2. Measure the resistance of the Driver Seat Back Heater Element between the (P187) Front Left Seat Heater Control and the (Z921) Ground circuit at the Driver Seat Back Heater connector.

Is the resistance above 8.5 ohms?

Yes

- Replace the Seat Back Heater Element.
- Perform BODY VERIFICATION TEST. Body Verification Test.

No

- Replace the Seat Cushion Heater Element.
- Perform BODY VERIFICATION TEST. Body Verification Test.