Fog Lamp - Installation

LAMP





1. From the face of the front fascia, position the front fog lamp and bracket unit into the fascia seat (1).
2. Engage the two alignment pins on the back of the fog lamp bracket with the alignment holes in the seat, then push the lamp rearward far enough to engage the three latch features (2) of the fog lamp bracket with the opening on the back of the seat.
3. Reach up between the lower edge of the front fascia and the front of the front wheel house splash shield to install and tighten the two screws (4) that secure the lamp to the back of the fascia. Tighten the screws to 2 Nm (18 in. lbs.).
4. Reconnect the front end module wire harness connector to the front fog lamp bulb connector receptacle (3).
5. Reconnect the battery negative cable.
6. Confirm proper front fog lamp alignment. Adjustments.