Fog Lamp - Removal

LAMP





1. Disconnect and isolate the battery negative cable.
2. Reach up between the lower edge of the front fascia and the front of the front wheel house splash shield to access and disconnect the front end module wire harness connector from the front fog lamp bulb connector receptacle (3).
3. Remove the two screws (4) that secure the lamp bracket to the back of the fog lamp seat (1) in the front fascia.
4. Disengage the three latch features (2) of the fog lamp bracket from the opening on the back of the seat and push the fog lamp forward far enough so the latch features are clear of the opening.
5. From the face of the front fascia, remove the fog lamp and bracket from the seat as a unit.