Generator Decoupler - Installation

INSTALLATION

INA Decoupler










1. Thread the decoupler pulley onto the generator shaft by hand (right-hand threads).
2. Position the Special Tool 8823 (VM.1048) into the decoupler.
3. Determine if the end of generator shaft is hex shaped or is splined. If hex is used, insert a 10MM deep socket (1) into the tool 8823 (VM.1048) or.










4. .if splined, insert a 5/16" 6-point hex driver (1), or a 10MM 12-point triple square driver into tool 8823 (VM.1048).
5. Do not use an adjustable, ratcheting "click type" torque wrench. Most "click type" wrenches will only allow torque to be applied in a clockwise rotation. Use a dial-type or beam-type wrench. Tighten in the counterclockwise rotation and tighten to 110 Nm (81 ft. lbs.).
6. Install the accessory drive belt and generator Generator - Installation.
7. Connect the negative battery cable.

Litens Decoupler





1. Thread the decoupler pulley onto the generator shaft by hand (right-hand threads).
2. Position the Special Tool 8433A into decoupler. Align the tool to hex end of the generator shaft.
3. Do not use an adjustable, ratcheting "click type" torque wrench. Most "click type" wrenches will only allow torque to be applied in a clockwise rotation. Use a dial-type or beam-type wrench. Tighten in the counterclockwise rotation and tighten to 110 Nm (81 ft. lbs.).
4. Install the accessory drive belt, and generator Generator - Installation.
5. Connect the negative battery cable.