Operation CHARM: Car repair manuals for everyone.

Occupant Restraint Controller (ORC)






B2102-IGNITION RUN/START INPUT CIRCUIT HIGH







- When Monitored:
While the CAN bus ignition status is Run or signal not available (SNA) and the IOD status is "IN" the Occupant Restraint Controller (ORC) checks the (F201) Fused Run/Start Relay Output circuit voltage input range.

- Set Condition:
If the ORC detects that the ignition voltage greater than 24.25 volts ± 0.25 volts for 10 seconds.





1. VERIFY THAT DTC B2102-IGNITION RUN/START INPUT CIRCUIT HIGH IS ACTIVE

NOTE: Make sure the battery is fully charged.

1. Turn the ignition on.
2. With the scan tool, read Occupant Restraint Controller (ORC) DTCs.

Does the scan tool display active: B2102-IGNITION RUN/START INPUT CIRCUIT HIGH?

Yes

- Go To 2

No

- Perform the AIRBAG SYSTEM INTERMITTENT TEST procedure. Airbag System Intermittent Condition Test.

2. CHECK FOR CHARGING SYSTEM RELATED DTCs IN THE POWERTRAIN CONTROL MODULE (PCM)
1. With the scan tool in ECU View, select PCM and check for any Charging System related DTCs.

Does the scan tool display any Charging System related DTCs?

Yes

- Diagnose and repair the ECM/PCM DTCs and perform the appropriate verification test procedure. Verification Tests.

No

- Replace the ORC.
- Perform the AIRBAG SYSTEM VERIFICATION TEST. Airbag System Verification Test.