U1416

U1416-IMPLAUSIBLE SECURITY SIREN SIGNAL RECEIVED



- When Monitored:
While the Vehicle Theft and Security System (VTSS) is armed.

- Set Condition:
When the learned Siren information stored in the Intrusion Transceiver Module (ITM) does not match.





1. DETERMINING IF DIAGNOSTIC TROUBLE CODE (DTC) IS CURRENT

NOTE: Diagnose any related Communication DTCs before continuing.

1. With a scan tool, read and record DTCs.
2. With the scan tool, clear DTCs.
3. Turn the ignition off and remove the key from the ignition.
4. Lock and close all doors to allow the VTSS to go from pre-arm to armed status and wait one minute.
5. Disarm the VTSS.
6. Using the scan tool, read ITM DTCs.

Does the DTC reset?

Yes

- Inspect wiring from ITM to Siren for an intermittent open condition. Check connector terminals for push out, corrosion or loose terminal contact. If OK, replace the Siren.
- Perform the BODY VERIFICATION TEST. Body Verification Test

No

- Go to 2

2. INTERMITTENT CONDITION

NOTE: Check for any of the follow conditions:
- Poor wire to terminal connection
- Corroded terminals
- Pushed out or loose terminals
- Broken wire internal to the insulation

Were there any problems found?

Yes

- Repair the wiring as necessary.
- Perform the BODY VERIFICATION TEST. Body Verification Test

No

- DTC is not active at this time. Test complete.