Sunroof - Installation

INSTALLATION





1. Install the module brackets.
2. Install the drive motor, Sunroof Motor - Installation.
3. Install the sunshade, Sunroof Sunshade - Installation.
4. Install the trough.
5. Install the glass panel.
6. Raise rear end of sunroof module assembly (2) to the roof (1) and guide into position and start the rear fasteners (3).
7. Raise front end of sunroof module assembly (2) to the roof (1) and guide into position, start the remaining fasteners (3).
8. Visually line up the alignment guide holes with the guide holes in the roof of the vehicle.
9. Tighten the fasteners to 9 Nm (80 in. lbs.).
10. Tighten the nuts (4).





11. Connect the rear drain tube at the sunroof (1).





12. Connect the front drain tube (3) at the sunroof (2).
13. Install the wire harness.
14. Connect battery negative cable.
15. If equipped, install the overhead console, Overhead Console - Installation.
16. Perform the sunroof motor teach procedure, Programming and Relearning.
17. Test sunroof operation, adjust glass as necessary, Adjustments.
18. Install the headliner, Headliner - Installation.