Seat Cushion Side Shields - Installation

INSTALLATION

Anchor Cover





1. Position the anchor cover (1) back onto the side cover and secure the lower tabs (3).
2. Position the upper arrow clip (2) in place and seat fully.





3. Make sure the retaining clip (2) is seated onto the recliner handle (1) fully.





4. Seat the handle (1) onto the recliner shaft fully.

Manual/Passenger Seats





NOTE: The retaining clips may be destroyed during removal. Always replace with new clips.

1. Install new retaining clips onto the side shield.
2. Secure the front support hook (3) to the support wire and then position the corner support over the upper corner of the wire loop.





3. Rotate the back of the shield (1) down over the support wire (2) and engage the corner support to the support wire.





4. Secure the lower rear support hook (2) to the support wire (3) and seat the upper clips (1) fully into the seat cushion frame.





5. Install the screws.





6. Install the two screws at the rear of the side shield.





7. Install the seat belt anchor (3) and install the anchor bolt (2).
8. Tighten the bolt (2) to 43 Nm (32 ft. lbs.).





9. Position the anchor cover (1) back onto the side cover and secure the lower tabs (3).
10. Position the upper arrow clip (2) in place and seat fully.





11. Make sure the retaining clip (2) is seated onto the recliner handle (1) fully.





12. Seat the recliner handle (1) onto the recliner shaft fully.

Power Seats





NOTE: The retaining clips (4) may be destroyed during removal. Always replace with new clips.

1. Install new retaining clips (4) onto the side shield tabs.





2. Position the power seat switch (1) back into the seat side shield and seat the retaining tabs (2) fully.





3. Secure the support hooks (2) to the support wire (1).
4. Slide the shield forward and secure the corner support (5) to the support wire (1).
5. Seat the upper retaining clips (4) to the seat cushion frame fully.





6. Position the rear shield (2), slide the shield forward and engage the forward facing tongue (1) into the slot on the front shield.






NOTE: Passenger side shown, driver side is similar.

7. Position the rear side shield into place and install the screws.





8. Install the seat belt anchor (3) and install the anchor bolt (2).
9. Tighten the bolt (2) to 43 Nm (32 ft. lbs.).





10. Install the two screws at the rear of the side shield.





11. Position the anchor cover (1) back onto the side cover and secure the lower tabs (3).
12. Position the upper arrow clip (2) in place and seat fully.





13. Make sure the retaining clip (2) is seated onto the recliner handle (1) fully.





14. Seat the recliner handle (1) onto the recliner shaft fully.

Upper Fold Flat Shield





1. Slide the shield rearward until the side hook (1) is positioned behind the seat back hinge and the alignment pin (2) is positioned in the hole until fully seated.





2. Line up the the shield retaining clip to the slot in the seat back hinge (1) and seat fully.