Front

FRONT





1. Install caliper (4) to the caliper adapter (5).
2. Coat the caliper mounting bolts (3) with silicone grease. Begin with the bolt closet to the bleeder screws (top), Then install and tighten the bolts to 37 Nm (28 ft. lbs.).

CAUTION: Verify that the brake hose is not twisted or kinked before tightening the fitting bolt.

3. Install the brake hose banjo bolt (2) and brake hose to the caliper (4) with new seal washers and tighten fitting bolt to 31 Nm (23 ft. lbs.) if removed.
4. Remove the prop rod from the vehicle.
5. Bleed the area of repair for the brake system, If a proper pedal is not felt during bleeding an area of repair then a base bleed system must be performed.Service and Repair.
6. Install the wheel and tire assemblies Service and Repair.
7. Remove the supports and lower the vehicle.
8. Verify a firm pedal before moving the vehicle.