Electronic Stability Program (ESP) Switch - Removal

REMOVAL

WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.

NOTE: The Electronic Stability Control (ESC) switch is integral to the accessory switch bank and cannot be serviced separately. The complete accessory switch bank assembly must be replaced.

NOTE: The Electronic Stability Control (ESC) may also be referred to as Electronic Stability Program (ESP) depending on the vehicle model year and configuration. Certain components may also reference ESP, ESC, or use the traction control symbol.





1. Disconnect and isolate the battery negative cable.
2. Remove the center bezel from the instrument panel, Instrument Panel Bezel - Removal.
3. Remove the four screws (2) that secure the accessory switch bank (3) to the back of the center bezel (1) and remove the switch bank.