Rear

REMOVAL






NOTE: The rear timing belt cover has O-rings to seal the water pump passages to cylinder block. Do not reuse the O-rings.

1. Perform fuel pressure release procedure. Service and Repair.
2. Disconnect and isolate the negative battery cable.
3. Drain the cooling system Service and Repair.
4. Remove timing belt (4) Timing Belt - Removal.
5. Remove camshaft sprockets (2 and 7) Timing Belt - Removal.





6. Remove the generator Generator - Removal.





7. Remove three pump mounting bolts (3) through pump pulley (1) and reposition the power steering pump.










8. Remove rear timing belt cover bolts (1, 2, 4).
9. Remove the rear cover.