Compressor Clutch Coil: Testing and Inspection

A/C CLUTCH COIL

The A/C clutch coil electrical circuit is controlled by the Powertrain Control Module (PCM) through the Totally Integrated Power Module (TIPM) A/C Compressor - Operation. Begin testing of a suspected A/C clutch coil problem by performing the preliminary checks.

PRELIMINARY CHECKS

1. Using a scan tool, check for Diagnostic Trouble Codes (DTCs) in the A/C-heater control, TIPM and the PCM. If no DTCs are found, go to 2. If any DTCs are found, repair as required.
2. If the A/C clutch still will not engage, verify the refrigerant charge level Component Tests and General Diagnostics. If the refrigerant charge level is OK, go to 3. If the refrigerant charge level is not OK, adjust the refrigerant charge as required.
3. If the A/C clutch still will not engage, disconnect the wire harness connector from the A/C pressure transducer and check for battery current at the connector with the engine running and the A/C-heater control set to the A/C mode. If OK, go to COIL CURRENT DRAW TEST and/or COIL RESISTANCE TEST - 4.0L ENGINE ONLY.

COIL CURRENT DRAW TEST

1. Verify the battery state of charge Battery.
2. Connect an ammeter (0 to 10 ampere scale selected) in series with the A/C clutch coil feed terminal using Back Probe Tool 6801. Connect a voltmeter (0 to 20 volt scale selected) to measure voltage across the battery and the clutch coil.
3. With the A/C-heater control in the A/C mode and the blower motor at low speed, start the engine and allow it to run at a normal idle speed.
4. The A/C clutch should engage immediately, and the clutch coil supply voltage should be within two volts of the battery voltage. If the clutch coil supply voltage is OK, go to 5. If the clutch coil supply voltage is not within two volts of battery voltage, test the clutch coil feed circuit for excessive voltage drop and repair as necessary.
5. See the A/C Clutch Coil Specifications chart for the acceptable A/C clutch coil current draw. If voltage is more than 12.5 volts, add electrical loads by turning on electrical accessories until voltage reads below 12.5 volts.
a. If the A/C clutch coil current reading is zero, the coil is open and must be replaced.
b. If the A/C clutch coil current reading is above specifications, the coil is shorted and must be replaced.

COIL RESISTANCE TEST - 4.0L ENGINE ONLY

1. Disconnect and isolate the negative battery cable.
2. Disconnect the wire harness connector from the A/C clutch coil connector.
3. Use an ohmmeter and Back Probe Tool 6801, measure the resistance of the clutch coil at the coil connector terminals.
4. See the A/C Clutch Coil Specifications chart for the acceptable A/C clutch coil resistance.
a. If the A/C clutch coil resistance reading is above specifications, the coil is shorted and must be replaced.
b. If the A/C clutch coil resistance reading is below specifications, the coil is open and must be replaced.
A/C CLUTCH COIL SPECIFICATIONS