Front Lamp Unit Bulb - Installation

BULB - PARK/TURN SIGNAL

CAUTION: Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket or the lamp wiring.





1. Align the base of the bulb with the park/turn signal bulb socket.
2. Push the bulb straight into the socket until the base is firmly seated.
3. Align the socket and bulb with the keyed opening in the back of the front lamp unit housing (3) located on the back of the front end module (5).
4. Insert the socket and bulb into the housing until the socket is firmly seated.
5. Rotate the socket clockwise about 30 degrees to lock it into place.
6. Reconnect the wire harness connector (1) to the connector receptacle integral to the park/turn signal bulb socket on the back of the housing.
7. Reconnect the battery negative cable.