MP143 Transfer Case - Removal

REMOVAL




TYPICAL TRANSFER CASE





1. Raise vehicle.

CAUTION: Do not allow propshafts to hang at attached end. Damage to joint can result.

2. Remove the front and rear propeller shafts.Drive Shaft - Removal
3. Support transmission with jack stand.
4. Remove rear crossmember and skid plate, if equipped.
5. Disconnect transfer case vent hose (4).
6. Disconnect the transfer case shift motor electrical connector and position the harness aside.
7. Disconnect the wiring connector from the shift motor, if necessary.
8. Support transfer case with transmission jack and secure with chains.
9. Remove nuts (2) attaching transfer case (1) to transmission (3).
10. Pull transfer case and jack rearward to disengage transfer case form the transmission case.
11. Remove transfer case from under vehicle.