Occupant Restraint Controller (ORC)

B222A-00-VEHICLE LINE MISMATCH -







Theory of Operation
When powered, the Occupant Restraint Controller (ORC) performs an internal self test. The repair of this fault centers on verifying the ORC programmed and vehicle content configuration.
- When Monitored:
The ORC checks its feature configuration for a stored Vehicle Line and Country Code at power-up and initialization.

- Set Condition:
This Diagnostic Trouble Code (DTC) sets when the ORC detects a 2 consecutive message mismatches between the Vehicle configuration and the ORC configuration. Once set this DTC is latched active for the ignition cycle.





Always Perform the Pre-Diagnostic Troubleshooting procedure before proceeding. Restraints System Pre-Diagnostic Procedure.
REPLACE OCCUPANT RESTRAINT CONTROLLER (ORC)
1. Turn the ignition on.
2. With the scan tool, read ORC DTCs.

Does the scan tool display active B222A-00-VEHICLE LINE MISMATCH - DTC?

Yes

- WARNING: Turn the ignition off, disconnect the 12-volt battery and wait two minutes before proceeding. Failure to follow these instructions may result in possible serious or fatal injury.

- WARNING: If the Occupant Restraint Controller (ORC) is dropped at any time, it must be replaced. Failure to follow these instructions may result in possible serious or fatal injury.

- Replace the Occupant Restraint Controller (ORC).
- Perform the RESTRAINTS SYSTEM VERIFICATION TEST. Restraints System Verification Test.

No

- Perform the RESTRAINTS SYSTEM INTERMITTENT TEST. Restraints System Intermittent Condition Test.