With EVIC

B1427-REMOTE RADIO SWITCH INPUT CIRCUIT HIGH (WITH EVIC)







- When Monitored:
With the ignition on.

- Set Condition:
The Cluster Detects the Radio Control MUX (multiplex) circuit is open or shorted to voltage.





1. CHECK FOR ACTIVE DTC

NOTE: Before proceeding with this diagnostic procedure, verify the Left and Right Multifunction Switch and Clockspring harness connectors are properly seated and verify proper pin terminal tension. A loose connection at any of these connectors may cause this DTC to set.

1. Turn the ignition on.
2. With the scan tool, read the active DTCs.

Does the scan tool display this DTC as active?

Yes

- Go To 2

No

- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.

2. (X20) RADIO CONTROL MUX CIRCUIT SHORTED TO VOLTAGE




1. Turn the ignition off.
2. Disconnect the Right Steering Wheel Switch harness connector.
3. Turn the ignition on.
4. Measure the voltage on the (X20) Radio Control MUX circuit.

Is the voltage above 10.0 volts?

Yes

- Repair the (X20) Radio Control MUX circuit for a short to voltage.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Go To 3

3. LEFT REMOTE RADIO SWITCH
1. Turn the ignition off.
2. Connect the Right Steering Wheel Switch harness connector.
3. Disconnect the Left Remote Radio Switch harness connector.
4. Connect a 5 Amp fused jumper wire between cavity 1 and cavity 2 in the Left Remote Radio Switch harness connector.
5. Turn the ignition on.
6. With the scan tool monitor the Remote Radio Control Switch voltage.

Is the voltage below 1.0 volt?

Yes

- Replace the Left Remote Radio Switch.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Go To 4

4. RIGHT REMOTE RADIO SWITCH
1. Turn the ignition off.
2. Connect the Left Remote Radio Switch harness connector.
3. Disconnect the Right Remote Radio Switch harness connector.
4. Connect a 5 Amp fused jumper wire between cavity 1 and cavity 2 in the Right Remote Radio Switch harness connector.
5. Turn the ignition on.
6. With the scan tool monitor the Remote Radio Control Switch voltage.

Is the voltage below 1.0 volt?

Yes

- Replace the Right Remote Radio Switch.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Go To 5

5. (X20) RADIO CONTROL MUX CIRCUIT OPEN




1. Turn the ignition off.
2. Disconnect the Right Steering Wheel Switch harness connector.
3. Measure the resistance of the (X20) Radio Control MUX circuit.

Are the resistances above 5.0 Ohms?

Yes

- Repair the (X20) Radio Control MUX circuit for a open.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Replace the Right Steering Wheel Switch.
- Perform the BODY VERIFICATION TEST. Body Verification Test.