B1C17-95

B1C17-95-PASSENGER ACTIVE HEADREST CONTROL - INCORRECT ASSEMBLY



- When Monitored:
The Occupant Restraint Controller (ORC) continuously monitors the Driver and Passenger Head Restraint Solenoid circuits for head restraint messages. The Driver and Passenger Head Restraint communication and on board diagnostics are powered by the ORC signal.

- Set Condition:
The Totally Integrated Power Module (TIPM) sends a configuration message to the ORC containing the Driver and Passenger configuration status. This DTC will set if the ORC is not configured for Driver and Passenger Head Restraint and receives the Driver and Passenger Restraint communication messages on the Head Restraint Solenoid circuits.





1. VERIFY ACTIVE DTC

NOTE: Make sure the battery is fully charged.

1. Turn the ignition on.
2. With the scan tool, read the ORC DTCs

Does the scan tool display active B1C17-95-PASSENGER ACTIVE HEADREST CONTROL - INCORRECT ASSEMBLY DTC?

Yes

- Go To 2

No

- Test Complete, the condition or conditions that originally set this DTC are not present at this time.
- Perform the RESTRAINTS SYSTEM INTERMITTENT TEST. Restraints System Intermittent Condition Test.

2. VERIFY ORC CONFIGURATION
1. Replace or reprogram the TIPM.
2. Perform the BODY VERIFICATION TEST. Body Verification Test.
3. Turn the ignition on.
4. With the scan tool, read the ORC DTCs
5. Cycle the ignition Off and then On.
6. With the scan tool, read the ORC DTCs

Does the scan tool display active B1C17-95-PASSENGER ACTIVE HEADREST CONTROL - INCORRECT ASSEMBLY DTC?

Yes

- Replace ORC.
- Perform the RESTRAINTS SYSTEM INTERMITTENT TEST. Restraints System Intermittent Condition Test.

No

- Test Complete, the condition or conditions that originally set this DTC are not present at this time.
- Perform the RESTRAINTS SYSTEM INTERMITTENT TEST. Restraints System Intermittent Condition Test.