B2599-54

B2599-54-DOOR MODULE FRONT RIGHT - MISSING CALIBRATION - QUAD/CREW CAB ONLY



Theory of Operation

This code can set anytime the battery or the door module connector is disconnected.

- When Monitored:
Whenever the window motor is operating.

- Set Condition:
When the Door Module has lost the parameters for window travel.





1. TEST FOR INTERMITTENT CONDITION

NOTE: If there are any other Power Window DTCs, repair them before continuing.

1. Turn the ignition on.
2. With the scan tool, record and erase DTCs.
3. Operate the Passenger Window switch up and down several times.
4. Wait 30 seconds.
5. With the scan tool, read the active DTCs.

Does the scan tool display B2599-54-DOOR MODULE FRONT RIGHT - MISSING CALIBRATION?

Yes

- Go To 2

No

- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

2. WINDOW MODULE NOT CALIBRATED
1. Operate the window to the full up position and continue to hold the switch for an additional two seconds.
2. Operate the window to the full down position and continue to hold the switch for an additional two seconds.
3. Again operate the window to the full up position and continue to hold the switch for an additional two seconds.
4. Lower the window all the way down then press and release the switch to the express up position.

Did the window move to the full up position?

Yes

- Test complete.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Go To 3

3. EXPRESS WINDOW SWITCH
1. Turn the ignition off.
2. Move the Passenger Express Window Switch from the idle position to the up position and then to the express up position.

Is there two definite detent positions felt?

Yes

- Replace the Passenger Door Module.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Replace the Passenger Express Window Switch.
- Perform the BODY VERIFICATION TEST. Body Verification Test.