Totally Integrated Power Module (TIPM)

B210D-BATTERY VOLTAGE LOW



- When Monitored:
With the ignition on.

- Set Condition:
Battery voltage less than 9 volts for more than 15 seconds.





CHECK FOR ANY ENGINE CONTROL MODULE DIAGNOSTIC TROUBLE CODES (DTCS)

NOTE: Make sure the battery is in good condition. Using the Midtronics Battery Tester, test the battery before continuing.

NOTE: Inspect the vehicle for after market accessories that may exceed the Generator System output.

NOTE: Make sure the generator drive belt is in good operating condition.

NOTE: Inspect the fuses in the Totally Integrated Power Module (TIPM). If an open fuse is found, use the wire diagram/schematic as a guide, inspect the wiring and connectors for damage.

1. Turn the ignition on.
2. Using the scan tool, read active ECM DTCs.

Does the scan tool display any active battery or charging system DTCs?

Yes

- Testing and Inspection Perform the appropriate diagnostic procedure.

No

- Check the above conditions that can cause a low voltage condition. Repair as necessary.