D. Replace Left Temperature Actuator

1. Disconnect the negative battery cable.

2. Remove the glove box door.





3. Disconnect the left temperature actuator electrical connector (Figure 4).

4. Remove the left temperature actuator mounting screws (Figure 4).

5. Remove and discard the left temperature actuator (Figure 4).

6. Install the new left temperature actuator into position on the heater housing.

NOTE:
The orientation of the door is not critical. The actuator will be correctly orientated when the actuator calibration procedure is performed.

7. Install the left temperature actuator mounting screws (Figure 4). Tighten the screws to 9 in. lbs. (1 N.m).

8. Connect the vehicle electrical harness connector to the left temperature actuator (Figure 4).

9. Install the glove box door.

10. Connect the negative battery cable.

11. If no other actuators require replacement, continue with Section G. Actuator Calibration.

If the actuator test determined there are additional actuator(s) that require replacement, continue with the appropriate Section in this document to replace the actuator(s) that have active DTC's.