Operation CHARM: Car repair manuals for everyone.

B196C






B196C-00-POWER LIFTGATE CLOSE DIRECTION EXCESSIVE POSITION SENSOR COUNTS





For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
During Power Liftgate closing cycle.

- Set Condition:
If the Power Liftgate (PLG) Module detects that the Power Liftgate Drive Unit has generated excessive pulses during a full power cycle, this code will set.





1. DTC PRESENT
1. With the scan tool, record and erase DTCs.
2. Turn the ignition off, wait 10 seconds, then turn the ignition on.
3. Operate the Power Liftgate several times from stop to stop if possible.
4. With the scan tool, read ACTIVE DTCs.

Does the scan tool display; B196C-00-POWER LIFTGATE CLOSE DIRECTION EXCESSIVE POSITION SENSOR COUNTS?

Yes

- Go To 2

No

- Using the wiring diagram/schematic as a guide, inspect the wiring and connectors for an intermittent condition. Operate the liftgate several times and check for any binding conditions.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

2. BINDING LIFTGATE
1. Examine the liftgate for proper alignment, worn or binding hinges, weak liftgate prop assembly, loose/hard weatherstrip seal, for wear or anything that would cause an obstruction to proper operation.
2. If necessary manually operate the power liftgate on a known good vehicle and notice the effort needed to open and close for comparison.

Were there any mechanical problems found?

Yes

- Power Liftgate Operation.
- Perform the BODY VERIFICATION TEST. Body Verification Test for the related symptom(s).

No

- Go To 3

3. POWER LIFTGATE LATCH
1. With the scan tool, monitor the SECONDARY RATCHET SWITCH CLOSED.
2. Using a screwdriver, click the latch to the closed position while observing the scan tool.
3. Unlatch the latch by pressing the handle switch and observe the scan tool for a change of state.
4. Repeat this step several times while moving the liftgate in different positions and wiggling the harness to check for an intermittent open or shorted circuit.

Did the scan tool show the switch state changing correctly every time?

Yes

- Go To 5

No

- Go To 4

4. CHECK THE (Q76) LATCH SECONDARY POSITION SENSE CIRCUIT FOR A SHORT TO GROUND




1. Turn the ignition off.
2. Disconnect the Power Liftgate Latch harness connector.
3. Measure the resistance between ground and the (Q76) Latch Secondary Position Sense circuit.
4. Wiggle the harness while observing the Ohmmeter.

Is the resistance below 1,000 Ohms?

Yes

- Repair the (Q76) Latch Secondary Position Sense circuit for a short to ground.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Replace the Power Liftgate Latch assembly. Power Liftgate Latch - Removal.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

5. POWER LIFTGATE MODULE - POSITION SENSE OPEN
1. Operate the liftgate from the full closed position and put an obstacle in its path to make it reverse.

Did the liftgate reverse back to the closed position?

Yes

- Replace the Power Liftgate Drive Unit. Power Liftgate Drive Unit - Removal.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Replace the Power Liftgate Module. Power Liftgate Control Module - Removal.
- Perform the BODY VERIFICATION TEST. Body Verification Test.