B1E65

B1E65-00-RIGHT MIRROR SELECT SWITCH STUCK

For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
Continuously.

- Set Condition:
The Door Module senses the Right Mirror Select switch input for more than 30 seconds.





1. INSPECT DRIVER DOOR SWITCH ASSEMBLY FOR DAMAGE

NOTE: Diagnose and repair all LIN Bus related Diagnostic Trouble Codes (DTCs) before performing this test procedure.

1. Turn the ignition off.
2. Inspect the Driver Window/Door Lock Switch assembly for damage.

Is the switch assembly damaged?

Yes

- Replace the Driver Window/Door Lock Switch assembly. Power Window Switch - Removal.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Go To 2

2. INSPECT FOR OBJECT OR SUBSTANCE CAUSING RIGHT MIRROR SELECT SWITCH TO STAY OR STICK IN A PUSHED POSITION
1. Inspect the Right Mirror Select switch for anything that would cause it to stay or stick in a pushed position.

Is anything present that would cause the Right Mirror Select switch to stay or stick in a pushed position?

Yes

- Repair as necessary.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Go To 3

3. TEST FOR INTERMITTENT CONDITION
1. Turn the ignition on.
2. Using a scan tool, record and erase DTCs.
3. Press and release the Right Mirror Select switch several times and then wait 30 seconds.
4. Using a scan tool, read the DTCs.

Does the scan tool display; B1E65-00-RIGHT MIRROR SELECT SWITCH STUCK as active?

Yes

- Replace the Driver Window/Door Lock Switch assembly. Power Window Switch - Removal.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension.
- Perform the BODY VERIFICATION TEST. Body Verification Test.