Passive Entry Module (PEM)

B21DD-85-SYSTEM VOLTAGE - SIGNAL ABOVE ALLOWABLE RANGE





For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
The first 10 seconds after the ignition is turned to run.

- Set Condition:
When the Totally Integrated Power Module (TIPM) sends a message that the system voltage is above 16.0 volts, this code will set.





CHECK POWERTRAIN CONTROL MODULE (PCM) DTCs
1. With the scan tool, read PCM DTCs.

Are there any PCM Charging or Battery DTCs present?

Yes

- Testing and Inspection and perform the appropriate diagnostic procedure.

No

- This code is for information only. At some time there was a high battery system voltage. Check the battery and charging system for an intermittent failure.