U0014

U0014-00-CAN INTERIOR BUS (+) CIRCUIT HIGH

For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
Continuously when the ignition is on.

The battery voltage between 10 volts and 16 volts.

Ignition Off Draw (IOD) fuse installed.

Totally Integrated Power Module (TIPM) is configured correctly.

- Set Condition:
A short to voltage is detected on the CAN Interior Bus (125K) (+) circuit.





VERIFY DTC IS ACTIVE

NOTE: Make sure the IOD fuse is installed and the battery is fully charged before proceeding.

1. Turn the ignition on.
2. With the scan tool, read active DTCs.

Is this DTC active?

Yes

- and perform the diagnostic test procedure for DTC U0010-CAN INTERIOR BUS U0010.

No

- Stored Lost Communication DTCs and perform the Stored Lost Communication DTCs diagnostic procedure.