Quarter Trim Panel - Installation

INSTALLATION






NOTE: Right side shown, left side similar.

1. Position the quarter trim panel (2) back into the vehicle.
2. Position the front locating pin into the body and seat the push pin near the location pin fully.
3. Seat the clip at the top of the trim panel into the C-pillar first.
4. For the right side, seat the three front push pins.
5. For the left side, seat the two front push pins.
6. Seat the push pin at the rear of the quarter glass.
7. For the right side, connect the power outlet electrical connector (1).
8. For the left side, connect the flash light electrical connector and the power liftgate switch, if equipped.
9. Position the rear locating pin into the body and seat the remaining push pins (5).
10. Install the screws (4).

NOTE: Screw cap (3) must be discarded when ever it is removed and replaced with a new one.

11. Install a new screw cap (3).




12. Position the door weatherstrip (1) back and seat fully.
13. Install the rear door scuff plate. Scuff Plate - Installation
14. Install the D-pillar trim. D-Pillar Trim Panel - Installation
15. Install the load floor. Load Floor - Installation