Instrument Panel

INSTRUMENT PANEL

WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.





1. Reach through the lower center bezel opening of the instrument panel to position the low frequency antenna (1) to the instrument panel substrate.
2. Install and tighten the two screws (3) that secure the low frequency antenna to the instrument panel substrate. Tighten the screws securely.
3. Reconnect the instrument panel wire harness connector (2) to the low frequency antenna connector receptacle.
4. Reinstall the center bezel onto the instrument panel. Instrument Panel Center Bezel - Installation.
5. Reconnect the battery negative cable.