Rear

REAR

Special Tools:






NOTE: Take the proper precautions to protect the face of the floor console panel from cosmetic damage while performing this procedure.





1. Disconnect and isolate the negative battery cable.
2. Remove the floor console rear trim panel (1) from the back of the floor console using Trim Stick or equivalent. Disconnect any necessary electrical connectors and place the trim panel on a workbench.
3. Remove the six screws (1 and 3) that secure floor console rear duct (2) to the floor console rear trim panel (4).

NOTE: If the foam seal on the console rear duct is deformed or damaged, the seal must be replaced.

4. Remove the floor console rear duct from the floor console rear trim panel.





5. Using Trim Stick or equivalent, gently disengage the two retaining tabs (1 and 3) that secure each 2nd row heated switch (2) to the back of the floor console rear trim panel (4).
6. Remove the 2nd row heated switches, as necessary, from the floor console rear trim panel.