D Pillar Switch - Installation

INSTALLATION





1. Position the rear power liftgate switch (2) to the receptacle on the back of the switch bezel (1) being certain to align the spline on the top of the switch housing with the keyway at the top of the receptacle.
2. Using hand pressure, press the switch firmly and evenly into the receptacle until the two snap features (3) on each side of the switch housing snap into place and the switch is fully engaged in the receptacle.





3. Position the switch (2) and switch bezel (3) unit close enough to the bezel opening in the left quarter trim panel (1) to access and connect the body wire harness connector to the connector receptacle on the bottom of the switch housing.
4. Align the switch bezel to the quarter trim panel bezel opening and, using hand pressure, press the bezel firmly and evenly into the opening until the two latch features integral to the back of the bezel are fully engaged.
5. Reconnect the battery negative cable.