A/C Compressor - Removal

3.6L ENGINE

WARNING: Refer to the applicable Warnings and Cautions for this system before performing the following operation Warning and Caution . Failure to follow these instructions may result in possible serious or fatal injury.

NOTE: The A/C condenser must be replaced if an internal failure of the A/C compressor has occurred A/C Condenser - Removal .

NOTE: The A/C compressor may be removed and repositioned without disconnecting the refrigerant lines or discharging the refrigerant system. Discharging is not necessary if servicing the A/C clutch, clutch coil or engine.

NOTE: LHD model shown in illustrations. RHD model similar.





1. Disconnect and isolate the negative battery cable.
2. Remove the engine trim cover.
3. Recover the refrigerant from the refrigerant system Refrigerant System Recovery.
4. Remove the air cleaner housing Air Cleaner Body - Removal.
5. Remove the accessory drive belt Serpentine Accessory Drive Belt - Removal.
6. Remove the nuts (1 and 3) that secure the A/C suction line (2) and A/C discharge line (3) to the A/C compressor.
7. Disconnect the refrigerant lines from the A/C compressor and remove and discard the seals.
8. Install plugs in, or tape over all of the opened refrigerant line fittings and the compressor ports.





9. Disconnect the engine wire harness from the A/C compressor (2).
10. Remove the nut (5) and position the heater tube and bracket (4) out of the way.
11. Support the A/C compressor and remove the stud (3) and the three bolts (1).
12. Remove the A/C compressor from the engine compartment.