Power Seat Switch - Removal

REMOVAL

Special Tools:






WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.

NOTE: Left side shown. Right side similar.





1. Position the seat being serviced all the way forward.
2. Disconnect and isolate the negative battery cable.
3. Remove the seat belt anchor trim panel (1) from the outboard seat cushion side trim panel (2) using Trim Stick or equivalent (3).






NOTE: It is not necessary to remove the seat belt anchor from the seat when servicing the power seat switch.

4. Remove the screw (1) that secures the seat cushion side trim panel (2) to the seat frame (3).





5. Using Trim Stick or equivalent (1), carefully disengage the tabs (2) that secure the seat cushion side trim panel (3) to the rear of the seat.





6. Slide the seat cushion side trim panel (1) forward to disengage the trim panel from the side of the seat.
7. Position the seat cushion side trim panel to gain access to the back of the power seat switch (4).
8. Using Trim Stick or equivalent (3), carefully disengage the four tabs (2 and 5) that secure the power seat switch to the seat cushion side trim panel.
9. Disconnect the electric connector (6) from the power seat switch and remove the switch.