Satellite Antenna - Installation

INSTALLATION

CAUTION: Do not stand on the tire or the bumper while servicing the antenna. Failure to follow the instructions will cause personal injury and/or vehicle damage.





1. Install the antenna mast (1) to the antenna base (2).
2. Insert wire harness through hole in roof panel. Press antenna into position until both retainers snap into place.





3. Connect the navigation (1), SDAR (2), AM/FM (3) and the 5 volt power (4) wire harness connectors to the antenna.
4. Install the retaining fastener.Tighten to 6 Nm (53 In. Lbs.)





5. Install the headliner (1) Headliner - Installation.

6. Connect the battery negative cable.