Dimmer Switch - Installation

INSTALLATION

WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.





1. Position the dimmer module (3) onto the back of the driver side outboard instrument panel trim molding (1).
2. Install and tighten the three screws that secure the dimmer module to the trim molding. Tighten the screws securely.
3. Reconnect the instrument panel wire harness connector (2) to the dimmer module connector receptacle.
4. Align the snap clips on the back of the trim molding with the receptacles in the instrument panel outboard of the steering column. Using hand pressure, press firmly and evenly on the bezel until the clips snap into place.
5. Reconnect the battery negative cable.