Power Liftgate Control Module - Installation

INSTALLATION





1. Position the Power Liftgate Module (PLGM) (2) to the left lower inner D-pillar (1) in the vehicle.
2. Engage the two tabs integral to the lower end of the PLGM housing into the slots in the lower left inner D-pillar.
3. Press the top of the PLGM housing against the lower left inner D-pillar far enough for the latch feature integral to the upper end of the PLGM housing to engage the clearance hole in the inner D-pillar.
4. Reconnect the two body wire harness (3) connectors to the PLGM connector receptacles.
5. Reinstall the quarter trim panel to the lower left inner D-pillar. Quarter Trim Panel - Installation.
6. Reconnect the battery negative cable.

NOTE: If a replacement power liftgate system component is installed or a mechanical liftgate adjustment is made, the PLGM must learn or relearn the effort and time required to open or close the liftgate. This learn/relearn cycle can be initiated using the power liftgate switches, using the Remote Keyless Entry (RKE) FOB with Integrated Key (FOBIK) or with a diagnostic scan tool connected to the Data Link Connector (DLC). Programming and Relearning .