Operation CHARM: Car repair manuals for everyone.

B1805






B1805-2A-PASSENGER DOOR LOCK/UNLOCK SWITCH - SIGNAL STUCK IN RANGE

For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
Continuously

- Set Condition:
When the Door Lock/Unlock Switch is stuck for over 30 seconds, this code will set.





1. TEST FOR INTERMITTENT CONDITION
1. With the scan tool, record and erase the DTCs.
2. Operate the Passenger Door Lock Switch in all positions several times.
3. Cycle the ignition from on to off.
4. Turn the ignition on.
5. With the scan tool, read the DTCs.

Does the scan tool display B1805-2A-PASSENGER DOOR LOCK/UNLOCK SWITCH - SIGNAL STUCK IN RANGE?

Yes

- Go To 2

No

- Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and poor pin fit.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

2. DOOR LOCK SWITCH
1. Check the switch for any objects that could cause a sticking condition.

Was anything found that could cause a sticking condition?

Yes

- Clean or remove the object as necessary.
- Perform the BODY VERIFICATION TEST. Body Verification Test.

No

- Replace the Passenger Window/Door Lock Switch. Power Window Switch - Removal.
- Perform the BODY VERIFICATION TEST. Body Verification Test.