U0132

U0132-00-LOST COMMUNICATION WITH SUSPENSION CONTROL MODULE

For a complete wiring diagram, refer to the Wiring Information.

- When Monitored:
Continuously when the ignition is on.

Battery voltage between 10 and 16 volts.

Ignition Off Draw (IOD) fuse installed.

Totally Integrated Power Module (TIPM) is configured correctly.

- Set Condition:
Bus messages not received from the TIPM for approximately two to five seconds.





VERIFY DIAGNOSTIC TROUBLE CODE (DTC) IS ACTIVE

NOTE: Make sure the IOD fuse is installed and battery voltage is between 10 and 16 volts before proceeding.

1. With the scan tool, read active Cluster DTCs.

Is this DTC active?

Yes

- and perform the U0141-Lost Communication with IPM (FCM/TIPM) diagnostic procedure U0141.

No

- Stored Lost Communication DTCs and perform the Stored Lost Communication DTCs diagnostic procedure.