C-Pillar Trim Panel - Installation
INSTALLATION
1. Position the seat belt (4) through the hole in the trim (3).
2. Position the C-pillar trim panel (3) to the C-pillar and engage the upper retaining tabs (1) that secure the trim panel to the C-pillar.
3. Seat the clips (2) fully.
4. Connect the tether to the trim panel.
5. Secure the retaining tab (1) of the headliner trim panel (2) to the C-pillar trim.
6. Position the upper headliner trim (1) and engage the alignment pin (3). Seat the retaining clips fully.
7. Install the trim screws (4).
8. Position the air bag back and seat the push pins (1) fully.
9. Install the quarter trim panel. Quarter Trim Panel - Installation
10. Position the door weatherstrip (1) back and seat fully.
11. Position the rear outboard seat belt (4) lower anchor to the rear seat back bracket (2) on the rear floor panel (3). Be certain the seat belt webbing between the turning loop and the lower anchor is not twisted.
12. Install and tighten the screw (1) that secures the seat belt lower anchor and the rear seat back bracket to the rear floor panel. Tighten the screw to 50 Nm (37 ft. lbs.).