Remote Start Antenna - Removal

REMOVAL





The Remote Start Antenna Module Assembly consists of an electrical connection to the Wireless Ignition Node (WIN) (1), a length of coax cable (2), mounting clips or tie wraps (3) and (4), and a control module/antenna (5).

The control module is located between the passenger side air bag and the glove box liner. The module electrical connector plugs into the WIN attached to the ignition switch located near the right side of the steering column.

1. Disconnect and isolate negative cable from battery.
2. Remove the drivers scuff plate Scuff Plate - Removal.






NOTE: Passenger side shown, drivers side similar.

3. Remove the drivers cowl trim panel Cowl Trim Panel - Removal.
4. Remove the drivers side silencer pad.
5. Remove the steering column opening cover Steering Column Opening Cover - Removal.





6. Remove the right side knee blocker support bracket.





7. Remove the glovebox Instrument Panel Glove Box - Removal.
8. Remove the glovebox liner.





9. Remove the instrument panel center bezel Instrument Panel Center Bezel - Removal.





10. Through the steering column opening disconnect the Wireless Ignition Node (WIN) antenna connector (1) from the WIN (2).





11. Unclip the two WIN antenna (2) harness clips (1) from the support.





12. Through the glove box opening (2) release the two antenna harness clips (1) from the back of the instrument panel.






NOTE: The antenna is located between the passenger side airbag (3) and the glove box opening support (4).

13. Remove the retainers (1) from the remote start antenna (2).
14. Gently pull the cable out from behind the instrument panel.