Second Row Seats

INSTALLATION

COVER - 60% SEAT BACK





1. Position the seat back foam on the seat back frame, if required.
2. Route the seat belt and headrest rods through the seat back cover, position the cover over the foam (2).





3. Seat the strip fasteners (1) into the seat foam clips (2) fully and secure the hook and loop fastener strips.





4. Position the cover (1) back in the armrest well and seat the eight push pin fasteners (2) fully.





5. Position the armrest back into the well and engage the left pivot pin.
6. Rotate the armrest back up into the installed position.





7. Position the foam (2) aside.
8. Make sure the right pivot pin is position correctly and install the armrest pivot bolt (1).
9. Tighten the pivot bolt (1) to 22.5 Nm (16.5 ft. lbs.)





10. Install and seat the armrest trim (3) fully.
11. Connect the strap (2).
12. Install the headrest sleeves (1) and seat fully.
13. Install the center seat bezel and seat fully.





14. Press the headrest sleeve release buttons and install the center headrest.





15. Install the seat back panel (2).
16. Install the lower seat cover straps and push pins.
17. Install the remaining push pins (1) and seat fully.





18. Lower the rear of the seat back cover (1) and secure the side zippers (2).





19. Secure the seat back cover (2) lower J-straps (1).





20. Install the seat belt anchor (1) bezels and seat fully.
21. Install the outer headrests. Headrest - Installation
22. Install the seat back assembly. SEAT BACK

COVER - 40% SEAT BACK





1. Position the seat back foam on the seat back frame, if required.
2. Position the seat back cover over the seat back foam and seat the strip fasteners (1) into the seat foam clips (2) fully and secure the hook and loop fastener strips.





3. Install the seat back panel (1).
4. Install the lower seat cover straps and push pins (3).
5. Install the remaining push pins (2) and seat fully.





6. Lower the rear of the seat back cover and secure the side zippers (1).
7. Install the seat belt anchor (2) bezel and seat fully.
8. Secure the seat back cover lower J-straps (3).
9. Install the outer headrests. Headrest - Installation
10. Install the seat back assembly. SEAT BACK

SEAT BACK





1. Position the seat back assembly onto the seat cushion assembly and install the pivot bolts (1).
2. Tighten the pivot bolts (1) to 22.5 Nm (16.5 ft. lbs.)





3. Secure the seat cushion cable housing (2) to the seat back assembly and connect the cable end (1) to the arm.





4. Install the side covers (2).





5. Connect the cable (2) if necessary.
6. Install the side cover (1).
7. Connect the electrical connectors, if equipped.
8. Install the side covers.
9. Install the recliner handle.
10. Install the seat. Service and Repair