Rear

REAR





1. Install the 2nd row heated seat switches (2), as necessary, into the floor console rear trim panel (4). Push the switches firmly into the trim panel until the retaining tabs (1 and 3) are fully engaged.






NOTE: If the foam seal on the console rear duct is deformed or damaged, the seal must be replaced.

2. Install the floor console rear duct (2) onto the floor console rear trim panel (4).
3. Install the six screws (1 and 3) that secure floor console rear duct to the floor console rear trim panel. Tighten the screws securely.
4. Install the floor console rear trim panel (1) onto the back of the floor console. Be sure to connect any necessary electrical connectors and properly align the console ducts.
5. Reconnect the negative battery cable.
6. Verify proper 2nd row heated seat system operation.