Second Row Seats

REMOVAL

Special Tools:






SEAT BACK





1. Remove the rear seat assembly. Service and Repair
2. Remove the recliner handle.
3. Remove the side cover.
4. Disconnect the recliner cable from arm.
5. Disconnect the electrical connectors, if equipped.





6. Remove the seat back pivot bolts.

COVER - 40% SEAT BACK

1. Place the seat back face down on a clean work surface.
2. Remove the headrest. Headrest - Removal




3. Using trim stick or equivalent, remove the anchor bezel (1) from the seat back panel (2).





4. Release the seat back cover lower J-straps (1).
5. Release the two side zippers (2).





6. Open the seat back cover and remove the upper push pins (2) from the seat back panel (1).
7. Remove the lower push pins (3) and release the seat cover straps.
8. Remove the seat back panel (1).





9. Separate the seat back cushion and cover from the frame and remove.
10. Open the cover (1) and expose the strip fasteners (2).
11. While pulling down on the seat cushion foam (3), slide the strip fasteners (2) out of the foam and release.

COVER - 60% SEAT BACK





1. Place the seat back face down on a clean work surface.
2. Remove the outer headrest. Headrest - Removal
3. Using trim stick or equivalent, remove the anchor bezels (1) from the seat back panel (2).





4. Release the seat back cover lower J-straps (1).





5. Release the two side zippers (2).





6. Open the seat back cover and remove the upper push pins (1) from the seat back panel (2).
7. Remove the lower push pins and release the seat cover straps.
8. Remove the seat back panel (2).





9. Push in the buttons on both headrest sleeves, pull the center headrest up and remove.





10. Remove the center seat belt bezel.
11. Release the strap (2) and remove the center headrest sleeves (1).
12. Remove the armrest trim (3).





13. Position aside the right side cushion and cover (2) and remove the armrest pivot bolt (1).





14. Rotate the right side (1) of the armrest (2) down and release the armrest from the seat back assembly.





15. Remove the eight push pin fasteners (2) and separate the upper cover (1) at the headrest mount.





16. Separate the seat back cushion and cover from the frame and remove.
17. Open the cover (1) and expose the strip fasteners (2).
18. While pulling down on the seat cushion foam (3), slide the strip fasteners (2) out of the foam and release.