Vented Seat Motor - Installation

INSTALLATION

NOTE: LHD passenger seat shown in illustrations. RHD and driver seat similar.

SEAT BOTTOM CUSHION MOTOR






NOTE: Illustration shown with seat cover removed from cushion.

1. If removed, install the vented seat duct (2) onto the vented seat pad (1). Be sure the retaining tab (4) is fully engaged.
2. Position the vented seat motor (3) to the vented seat duct and carefully engage the four retaining clips that secure the vented seat motor (3) to the duct. Be sure the retaining clips are fully engaged.

NOTE: On all models, the front passenger seat bottom cushion contains an Occupant Detection Sensor (ODS) to provide information to the Occupant Restraint Controller (ORC). Be sure to reconnect the wire harness connector for the ODS once the front passenger seat bottom cushion and cover are installed Occupant Detection Sensor - Installation .

3. Install the seat bottom cushion.





4. Position the vented seat motor to the seat cushion pan (4), install the two nuts (1) and engage the two push pin retainers (2). Tighten the nuts securely.
5. Connect the vented seat motor electrical connector (3).
6. Install the seat bottom cushion cover.
7. When servicing the driver seat, install the memory seat module and bracket Memory Seat Module - Installation.
8. When servicing the passenger seat, install the heated seat module and bracket Heated Seat Module - Removal.





9. Engage the heated seat pad electrical connector (1) to the seat cushion pan (3).
10. Connect the heated seat pad electrical connectors (2 and 4).

NOTE: On all models, the front passenger seat bottom cushion contains an Occupant Detection Sensor (ODS) to provide information to the Occupant Restraint Controller (ORC). Be sure to reconnect the wire harness connector for the ODS once the front passenger seat bottom cushion and cover are installed Occupant Detection Sensor - Installation .

11. Install the seat Service and Repair.
12. Reconnect the negative battery cable.
13. Verify proper vented seat system operation.

SEAT BACK CUSHION MOTOR





1. Position the vented seat motor (2) to the vented seat pad (1) and carefully engage the four retaining clips that secure the motor to the pad. Be sure the retaining clips are fully engaged.





2. Position the seat back cushion and cover onto the seat back frame (2).
3. Engage the vented seat motor electrical harness retainer (1) and the connector (4) to the seat back frame.
4. Connect the vented seat motor electrical connector (3).





5. Position the vented seat motor (3) to the seat back frame (2) and install the four nuts (1). Tighten the nuts securely.
6. Install the seat back cushion cover onto the seat back frame.





7. Connect the air bag electrical connector (1) and seat back heated pad electrical connector (3) at the seat cushion pan (2).
8. Install the seat Service and Repair.
9. Reconnect the negative battery cable.
10. Verify proper vented seat system operation.