Rear Suspension Stabilizer Bar - Installation

INSTALLATION






NOTE: When the stabilizer bar or links are serviced it is recommended that a drive on hoist is used or the out board ends of the control arms are supported and raised to normal ride height. If the suspension is hanging, there will be tension on the stabilizer bar.

1. Position the stabilizer bar and install the upper (2) and lower (4) stabilizer bar to cradle bolts and tighten to 110 Nm (81 ft. lbs.).
2. Install both stabilizer link to stabilizer nuts (1) and tighten to 90 Nm (66 ft. lbs.).





3. Insert and seat the parking brake cable (1) into the open bracket (2).
4. Remove the supports and lower the vehicle.