Rear

INSTALLATION

NOTE: The rear A/C-heater control is located in the rear overhead console or in the headliner, depending on trim level.

HEADLINER MOUNTED

NOTE: Take the proper precautions to protect the face of the rear A/C-heater control and bezel from cosmetic damage while performing this procedure.





1. Position the rear A/C-heater control (4) to the rear control bezel (1) and align the control to the two plastic guide posts on the bezel.
2. Install the two screws (3 and 5) that secure the rear A/C-heater control to the bezel. Tighten the screws to 1.2 Nm (10 in. lbs.).
3. Connect the wire harness connector to the back of the rear A/C-heater control and install the control and bezel onto the headliner. Make sure the four retaining tabs (2) are fully engaged.
4. Reconnect the negative battery cable.
5. Calibrate the A/C-heater control HVAC System Test.

OVERHEAD CONSOLE MOUNTED

NOTE: Take the proper precautions to protect the face of the overhead console from cosmetic damage while performing this procedure.





1. Position the rear A/C-heater control (1) to the overhead console (3) and align the control to the two plastic guide posts on the top of the console.
2. Install the two screws (4) that secure the rear A/C-heater control to the rear overhead console. Tighten the screws to 1.2 Nm (10 in. lbs.).
3. Connect the wire harness connector (2) to the back of the rear A/C-heater control.
4. Install the rear overhead console Overhead Console - Installation.
5. Reconnect the negative battery cable.
6. Calibrate the A/C-heater control HVAC System Test.