Park Assist Module - Installation

INSTALLATION





1. Position the park assist module (1) to the right quarter inner panel (2), to the rear of the C-pillar and above the right rear wheel housing.
2. Engage the two lower mounting tabs of the module into the stamped pockets in the right quarter inner panel.
3. Secure the upper mounting tab of the module to the right quarter inner panel using a plastic push-in fastener (4).
4. Reconnect the two body wire harness connectors (3) to the module connector receptacles.
5. If removed, install the passive entry antenna on vehicles equipped with the passive entry.
6. Reinstall the trim onto the right quarter inner panel. Quarter Trim Panel - Installation.
7. Reconnect the battery negative cable.