Dimmer Switch - Installation

INSTALLATION

WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.





1. Reach through the steering column opening of the instrument panel to position the dimmer module (3) onto the back of the instrument panel base trim (1).
2. Install and tighten the three screws (4) that secure the dimmer module to the back of the instrument panel base trim. Tighten the screws securely.
3. Reconnect the instrument panel wire harness connector to the dimmer module connector receptacle (2).
4. Reinstall the steering column opening cover and knee blocker unit onto the instrument panel. Steering Column Opening Cover - Installation.
5. Reconnect the battery negative cable.