Light Emitting Diode Unit

LAMP - LIGHT EMITTING DIODE

EXCEPT WITH OVERHEAD CONSOLE





1. Position the dome/reading lamp to the headliner mounting hole.
2. Reconnect the wire harness connector to the back of the lamp.
3. Insert the fixed retainers on one edge of the lamp housing up over the edge of the mounting hole in the headliner.
4. Slide the lamp housing into the mounting hole far enough to engage the other edge of the lamp housing into the hole in the headliner.
5. Gently and evenly press the lamp housing into the mounting hole until the bezel is flush with the headliner.
6. Swing the lock tab up against the lamp bezel and align it with the opening (1) between the two Light Emitting Diode (LED) pod units.
7. Press upward firmly and evenly on the lock tab until it snaps into the lamp bezel opening.
8. Reconnect the battery negative cable.

WITH OVERHEAD CONSOLE





1. Position dome/reading lamp to the overhead console mounting hole.
2. Reconnect the wire harness connectors (1) to the back of the lamp.
3. Align the lamp housing to the overhead console mounting hole.
4. Press upward firmly and evenly on the lamp bezel until the four (two at the front and two at the rear) integral latch features snap into place.
5. Reconnect the battery negative cable.