Headlamp Alignment Actuator - Removal

REMOVAL






NOTE: The graphic shows the right side front lamp unit as viewed from the back of the lamp with the housing removed. However, the housing cannot be removed from the lamp for service. This view was necessary in order to clearly illustrate the internal engagement of the headlamp leveling motor pushrod with the saddle bracket on the lamp reflector.

1. Disconnect and isolate the battery negative cable.
2. Remove front lamp unit from the vehicle. Front Lamp Unit - Removal.
3. Rotate the headlamp leveling motor (4) on the back of the lamp housing counterclockwise about 30 degrees to unlock it from the housing.
4. Grasp the motor firmly with one hand and twist it toward the inboard side of the lamp far enough to disengage the ball on the end of the motor pushrod (3) from the saddle bracket (1) secured to the reflector (2) within the lamp housing.
5. Pull the motor and pushrod straight back and out of the front lamp unit housing.